World’s 1st Power Optimisation System with User Output Voltage Control

The PropSava SCRV is the World’s first 3 Phase automated voltage regulator and stabiliser that the User can set their own Output voltage. The User can increase or reduce the output voltage - the same OR different values on each phase to their site. Changing the Output voltage offers greater reduction in electric power consumption than has previously been possible.

Each Phase has its own computer system, safety controls, transformers and sensors.  This provides the benefit of increased performance and reliability of the SCRV System over any other type of voltage regulator currently available.

The SCRV System uses solid state switching managed by three state-of-the-art digital computer systems. Output voltage is changed via the digital keypad on each phase. The Output Voltage can also be changed over a network or Internet subject to installation of the VP Remote Control System (available 2nd Quarter 2012).

The PropSava SCRV provides greater advantages to the User over any other type of Power Optimisation System in the world such as:

• Increasing site energy savings and reducing further CO2 emissions,
• Managing voltages more efficiently on older type equipment,
• Controlling production facility performance accurately,
• Ability to run lighting systems at lower voltage values then mains equipment.                                 

The PropSava SCRV is much safer (7 standards safety systems) and more reliable than other Regulator such as step-down transformers, servo-operated etc. and has the largest regulation range at 18% - 305V to 440V incoming voltage; regulated and stabilised to your Output setting of 210V to 230V.

The PropSava is connected after the electric meter and Master Breaker Switch and before the Distribution/Fuse Box. All power to a site/building passes through the PropSava.

Sites/buildings that use the PropSava SCRV Power Optimisation System will benefit from:
• Paying less for their electricity.
• Reduction in CO2 emissions and carbon footprint; consuming less power means less power has to be generated and therefore less CO2 emitted.
• Reduction in Carbon Tax liability.
• Reduction in electrical equipment breakdowns, downtime and labour costs.
• Reduction in premature electrical equipment failure and the cost of early replacement.

PropSava SCRV Configuration Choices:
To provide our Customers with the greatest flexibility of choice to suit all site needs and budgets the PropSava SCRV is available in a variety of configurations. The 3 Main Configurations are as follows:

1.  Base Unit - Computer controlled automatic voltage regulator and stabiliser with standard Safety Systems including Auto Regulation OFF, Overload, over and under voltage protection and System Temperature.
2.  External Protection System against Current or Voltage Surges – four choices of Surge and/or Voltage Protection.
3.  Product to Site By-Pass – three choices of Manual, Automatic and Total Disconnect System

The recommended Configuration for the 3 Phase PropSava System consists of a Base Unit, Current Surge Protection and Total Disconnect System (TDS) Product to Site By-Pass.This configuration provides the customer with the highest level of power optimisation performance, site power continuity and security for most sites.

Base Unit Standard Features and Safety Systems:
The Base Unit PropSava SCRV is a fully functional stand-alone system which has the following standard features:
1.   3 single Phase independent Solid State Digital Computer Controlled Voltage Regulators and Stabilisers.
2.   Dynamic ‘On-The-Fly’ User Changeable Output Voltage between 210V to 230V per phase stabilised at ±1.3%.
3.   Operational incoming main voltage range between 306V and 440V (18%).
4.   Computer Controlled Auto Regulation OFF when User Set Limits are exceeded - does not affect site power when operated.
5.   Manual Regulation ON and OFF Control - does not affect site power when operated.
6.   Main overload protection – Master Regulation Protection Switch (MRPS) - Equal to or less than Site Isolator size
7.   Over and Under Voltage protection safety system – Factory/User Set with audible and visual warnings.
8.   Over Load protection safety system – Factory/User Set with audible and visual warnings.
9.   System Temperature control safety system – with audible and visual warnings.
10. Temp System Reset.

External Protection Systems:
The External Protection Systems stop any power surges caused by outside sources, natural or man-made, damaging the PropSava and the site/building electrical equipment.

There are two choices available with two levels of protection for Current and Voltage – although a customer can select both Current and Voltage protection together if they wish:

1.  Surge Protection Device 1 – 20,000 Amps
2.  Surge Protection Device 2 – 30,000 Amps
3.  Voltage Surge Protection Device 3 – 25,000 Volts
4.  Voltage Surge Protection Device 4 – 40,000 Volts

Product to Site By-Pass Systems:
There are three choices for the Product to Site By-Pass System:
1. Manual Lever
2. Automatic
3. Total Disconnect System

VP UNIQUE PRODUCT & SERVICE OFFERING:

• World’s 1^st Computer Controlled Automatic Voltage Regulator & Stabiliser with User controlled Output Voltage.
• All Systems include ‘Cutting Edge’ safety systems at No Extra Charge.
• Products Independently Tested and Certified to CE & IEC safety standards.
• Custom Built to Meet Your Unique Site Requirements.
• VP Systems Sold, Installed and Maintained world-wide by VP Trained, Certified and Insured Channel Partners.
• 10 to 20 years Warranty.
• See all Your Existing and Historic Power Usage Over a LAN or Internet with our Power Quality Metering System.
• Free and Without Obligation Quotation Service. 
• Free 7 Full Days of Site Power Quality Logging Using EVO Protocols.